ResearchSafe

BAM15 – how do you actually measure a starting dose with insulin syringes?

Posted by fasted_scientist in Beginner Questions - 8 points, 4 comments.

5mg per day. The knowledge base says the typical dose isn’t established for humans, only research protocols exist. I’m trying to figure out how to translate that into something I can actually draw up with an insulin syringe.

1ml – which is 10 units on a standard 100‑unit insulin syringe. Does that sound right? I’m a bit nervous about getting the volume wrong because the compound is supposed to have a narrow safety window compared to DNP.

Has anyone here actually tried measuring out a tiny dose like this and noticed any effects, or did you just feel nothing? I’d love to hear what others did, especially if they checked blood glucose or temperature afterwards. Ngl, I’m keen to avoid guessing and would rather see some kind of log or study reference before I start.

Comments

  • restlessemma: I’ve measured sub‑milligram peptides before with a 1 ml insulin syringe, but the key is knowing the concentration after you reconstitute the powder. If you dissolve 5 mg in 1 ml of bacteriostatic water you get 5 mg/ml, so 1 ml would be the full 5 mg dose – that’s 100 units on a U‑100 syringe, not 10 units. 1 ml increments (50 µg) and log my fasting glucose and basal temp each morning. 2 °C bump that could just be placebo – but I always double‑check the math and run a baseline blood panel first,
  • fasted_scientist: Ngl, I am glad you pointed that out. I was way off with my maths, 10 units would have been a tiny fraction of what I wanted. If I did 10 units thinking it was 5mg, I would have been way underdosed. That 2 degree bump sounds massive though. Did you notice any sweating or anything with that temperature shift? I am definitely going to run a baseline panel first like you said.
  • curious_scientist: Yeah that math checks out – 5 mg in 1 ml gives 5 mg/ml so 1 ml is the whole 5 mg dose (100 U on a U‑100). I’ve done the same with BAM15, started at 0.01 ml (≈50 µg) and didn’t notice anything clear, just tracked glucose and temp like you mentioned. Always good to double‑check the dilution before drawing up.
  • fasted_scientist: Ngl I was slightly off with my unit math there, cheers for catching that. If 1ml is the full 5mg then 10 units would only be 0.5mg, not the whole dose. That is a massive difference. Since you started at 0.01ml, did you find that too small to even register on a standard glucose monitor? I am worried about the precision with these tiny volumes.

Community discussion - research and educational context only. Not medical advice.